Your apartment/house is worth the additional $$! (Note, I ordered the 3D print and optimised the STL thereafter, so I could not test it finally but it should be OK - else, a cutter is your friend to remove some plastic material from the Charging Pad).įor safety reasons, I went for a quality charger and charing pad, no cheap stuff from Aliexpress.
It fits the below Anker Wireless Charging Pad. The STL for 3D printing can be found here (Github). You could paint it as well if required - my tablet is sitting on the wall mount most of the time, so I did not paint it. Nevertheless, the tablet sits rock solid on the wall mount. Note, on the top right, its not a magnet, its a washer - the Fire HD 8 Plus tablet has a magnetic sensor sitting at that position (assuming for a cover that one could buy), so I was in need to replace the magnet with a washer to not turn off the display permanently, lol. I have an AC walloutlet behind this wall mount, thats where the charger is stored.
The Fire HD 8 Plus has an integrated wireless charger / Qi charger, no additional coil needed! Of course, the wall mount could be painted too, but for me this is just fine. It holds and charges a Fire HD 8 Plus tablet with no cables.
